Silt Density Index Kits and Test Equipment

Click Here to Purchase Our SDI Kits Online:

Portable SDI Test Kit

Portable Automatic SDI Kit

EZ SDI - Automatic SDI Tester

Suspended solids and colloidal materials in feed water are one of the biggest problems in reverse osmosis systems.  Even though most systems have some pretreatment including 5 micron prefilters, these fine particles are responsible for fouling of reverse osmosis membranes. 

In order to have some measure of the degree of this fouling problem, a concept called Silt Density Index is used.  Here a 0.45 micron filter is exposed to the feed water under pressure and filtration rates are calculated.  A detailed description of the test is available in our design information section - Click here to view the description.
 

An SDI of less than 5 is considered acceptable for the reverse osmosis systems.  This means that at values of SDI of less than 5, the membranes should foul at a very low rate.   Even though the concept works most of the time, there are exceptions when a lower SDI (less than 3) is desirable due to the nature of the suspended solids in that feed water. 

For prompt, courteous and reliable service, contact us today!