Aquatec Auto Flush Timers for Home RO Systems

Auto-flush Timer Valves regulate the product to waste ratio and automatically flush the membrane on each startup.

• Reduces "brine to product" ratio

• Improves system "TDS" rejection rate

• Extends membrane life

• Hermetically protected electronics for long life

Model No.	With Flow Restrictor	For Membrane Flow (GPD)	Image
AFR603	300 M/L per Min.	25
AFR604	400 M/L per Min.	35
AFR605	500 M/L per Min.	50
AFR606	600 M/L per Min.	50
AFR607	700 M/L per Min.	75
AFR608	800 M/L per Min.	75

Aquatec Auto Flush Timers assist the R.O. membrane to perform with maximum efficiency for longer time periods.   In addition, designers can reduce the "brine to product" ratio, especially in low "TDS" applications, while maintaining or improving system "TDS" rejection rate and extending membrane, sediment and carbon filter life. Upon system start-up and every hour thereafter, the 24 VAC normally closed solenoid valve automatically "power-flushes" the membrane at full pump flow, or full line pressure in unboosted systems, for 18 seconds every hour. Turbulent water action scrubs organic and inorganic contaminants from the membrane surface, extending membrane life and efficiency. The "power flush" occurs only while the system is in the water making mode. The flush cycle is reset automatically when the R.O. system repeats the "water making" mode after the "full tank shut-down" mode. Water which has been standing idle in the membrane module for an extended period, is purged to the drain. The AFR 600 requires its own transformer or can be powered by the pump transformer.

The valve has a built in, self cleaning, flow restrictor which allows controlled flow to drain when the valve is in the de-activated (closed) state. Flow restrictors from 300 to 700 mL/min. are available. Contact factory for higher flow rates.