跳至内容

HLS 高 TDS 微咸水

HLS系列RO系统适用于高TDS咸水(高达15,000 PPM)

AMI Small Commercial Reverse Osmosis Systems for High TDS Feed Water

  • 1,400 至 6,600 加仑/天反渗透系统
  • 适用于 TDS 高达 15,000 PPM 的给水

这些 RO 系统旨在从高 TDS 咸水井水或类似源水中生产低溶解固体水,使用 FRP 膜外壳中的高效反渗透膜。

该产品水适用于水库、全屋使用、制冰机、加湿、喷雾以及各种其他应用。

HLS系列反渗透系统专为耐受咸水的高腐蚀性而设计。所有高压管线和组件均采用耐腐蚀材料制成。

这些苦咸水反渗透 (BWRO) 系统运行压力在 350 至 500 psi 之间,采用粉末涂层金属框架,并采用可靠且久经现场验证的组件。周到的流体设计可确保最佳膜寿命并减少污垢。

HLS系列高盐度反渗透系统

HLS系列商用RO苦咸水系统产品线

RO 系统型号

RO系统
容量

反渗透膜
元素

管线尺寸
(NPT,英寸)

RO系统
尺寸(英寸/厘米)

大约运输重量
(磅/公斤)

国内生产总值

立方米/天

数量

尺寸
(直径×长)

进口

烫发。

浓度

长度

深度

高度

HLS-14A-116

1,400

5.3

1

4×40

1

½

½

20/51

24/61

55/140

400/181

HLS-24A-116

3,500

13.2

2

4×40

1

½

½

20/51

24/61

55/140

425/193

HLS-34A-216

4,600

17.4

3

4×40

1

½

½

20/51

32/82

55/140

450/204

HLS-44A-216

5,500

21

4

4×40

1

¾

¾

20/51

32/82

55/140

475/216

HLS-54A-216

6,200

23.5

5

4×40

1

¾

¾

20/51

32/82

55/140

500/227

HLS-64A-216

6,630

二十五

6

4×40

1

¾

¾

20/51

32/82

55/140

525/238


说明和电压/订购信息

  • 所有尺寸和重量均为近似值。
  • 容量基础: 24 小时/天
  • 系统额定温度为: 77°F (25°C),使用 15,000 ppm 氯化钠溶液,工作压力约为 350-500 psi。
  • RO系统最低进水压力: 40-60 PSI。系统容量随水温变化显著。
  • 如果进水中含有氯,则必须在进入 RO 系统之前用碳过滤器将其除去。
  • 应使用软化剂或阻垢剂注入对水硬度进行预处理,以避免膜结垢。
  • 进水浊度:小于1 NTU;进水粉尘密度指数 (SDI):最大3。如果超过,建议使用介质过滤器进行预处理。所有预处理设备和SDI测试套件均可从Applied Membranes公司购买。
  • 电压:订购时,请在型号末尾添加我们的电压代码。
    例如:HLS-14A- 216 = 220/230v,1 ph,60 hz。
  • 电压代码:
  • 216 = 220/230伏,1相,60赫兹
  • 236 = 220/230伏,3相,60赫兹
  • 436 =460/480伏,3相,60赫兹

推荐的预处理设备(单独出售)

  • 碳过滤器
  • 软水器
  • 多介质过滤器
  • 阻垢剂注入

HLS系列商用RO苦咸水系统优势

  • 紧凑、经济的高 TDS 咸水给水解决方案
  • 40 多年的经验体现在我们的质量上
  • 重型粉末涂层框架
  • 整个系统使用经过验证的组件
  • 保守设计,确保长期可靠的性能
  • 经过工厂测试,确保无故障运行

Standard Equipment for HLS Series Commercial RO Brackish Water Systems

  • Thin Film Composite RO Membranes
  • FRP Membrane Pressure Vessels
  • 5 Micron 20” Cartridge Filter & Housing
  • Feed Water Temperature
  • Automatic Inlet Feed Solenoid Valve
  • Permeate, Concentrate & Recycle Flowmeters
  • RO System Control Valve, Stainless Steel
  • Recycle Control Valve, Stainless Steel
  • Low Pressure Pump Protection
 
  • High Pressure Stainless Steel RO Pump
  • Automatic Membrane Flush with Fresh Water Pump
  • Liquid Filled Pressure Gauges for Filter IN/OUT and System Pressures
  • Feed and Permeate TDS Displayed on Controller LED with Percent Rejection
  • RO System ON/OFF With 2-Level Tank Floats
  • Stainless Steel and Corrosion Resistant Materials on High Pressure Side
  • Powder Coated Carbon Steel Frame
  • Boxed and Palletized For Shipment

Microprocessor Controller for Automatic Operation

Monitors and/or Controls:

  • Inlet valve
  • Delayed start-up of high pressure pump
  • Feed water flush at system shut-down
  • Low pressure switch
  • On/Off with tank level
  • Permeate Water Quality 
  • Pre-treatment backwash/lockout
  • Feed Water Quality and percent rejection
  • Water Temperature
  • Operating hours
  • RO tank full override

Controller Features:

  • Backlit LED Display
  • Multi-function keypad
  • Visual and audible alarm & silence key
  • Programmable time delays, set-points and
    flush mode
  • Visual indicator alarm light
  • Low pressure automatic restart

UL508A Labeled

controller_i-roc150s

I-ROC150S

 

LED Display:

  • Permeate TDS
  • Feed TDS with % Rejection
  • Water Temperature
  • Operating Hours
  • Operating Status
  • Alarm condition

Common Applications for HLS Series Commercial RO Brackish Water Systems

  • Spot Free Rinse/Car Wash
  • Water Stores
  • Whole House
  • Laboratories
  • Large Office
  • Institutions
  • Ice Makers
  • Humidification
  • Misting
  • Commercial
  • Manufacturing
  • Rinse Water
  • And a wide variety of other applications
Reverse Osmosis Water Filtration Systems for Car Wash Spot Free Rinse

Optional Add-On Parts and Equipment for Commercial RO Systems

AMI's HLS Series High TDS RO Systems are available with a wide variety of optional add-on equipment. All assemblies include hardware and mounting equipment for easy upgrade to your new or existing system installation.


Wall Mount Filter Cartridges

Wall Mount Prefilter for Commercial RO Systems

Includes mounting bracket and Isolation Valves to close the line when changing the filter cartridge.

Part # A711

Filter cartridge must be ordered separately - common options are shown below. Any 20" Big Blue size cartridge can be installed.  Click here to view our complete filter cartridge product selection.


Softeners & Media Filtration Pre/Post Treatment

Water Softener and Media Filter for Commercial RO Systems AMI Media filters feature fully automatic backwash or regeneration for easy, trouble free maintenance. Ensure superior system operation and extended membrane life by providing proper pretreatment to the incoming feed water on a continuous basis. Common pretreatment or post-treatment methods include:

  • Single or Twin Water Softener to remove hardness and scale.
  • Multi-Media Filter for sediment filtration to approximately 10 microns.
  • Carbon Filter to remove chlorine.
  • Calcite Filter to neutralize the pH of the RO product water.

Click Here to visit the Media Filtration section of our site for detailed information on the full line of media filtration products we carry.


Chemical Injection System

Mineral Injection System for RO System Post-treatment Antiscalant injection as an alternative to a water softener for scale control, or

Sodium Metabisulfite injection as an alternative to a carbon filter to remove chlorine.


Water Quality Monitors

Water Quality Monitor for Commercial RO SystemsPre-packaged wall-mountable water quality monitoring controls allow you to monitor the quality of the incoming feed or RO product water. Assembly includes the monitor, enclosure and sensor.

Available Options for Monitoring Incoming Feed Water Quality:

  • ORP - 60Hz Part # A246, 50Hz Part # A247
  • pH - 60Hz Part # A244, 50Hz Part # A245

Available Options for Monitoring RO Product Water Quality:

  • Total Dissolved Solids (TDS) - 60Hz Part # A242, 50Hz Part # A243
  • Resistivity - 60Hz Part # A248, 50Hz Part # A249
  • pH - 60Hz Part # A244, 50Hz Part # A245

Ultraviolet (UV) Systems

Ultraviolet Disinfection for Commercial RO Systems Add an ultraviolet water sterilizer for a 99.9% reduction of bacteria and viruses in the feed and/or permeate line.

Note: For feed line, wall-mount filter cartridge assembly shown above is required.


Tank Pressure Controls

Tank Pressure Controls for Commercial RO Systems To automatically turn the RO system on or off with the permeate storage tank level. For use with a pressurized storage tank (sold separately).

  • 220v/60Hz - Part # A621

Pressurized Storage Tank

Pressurized Storage Tank for Commercial RO SystemsPressurized permeate storage tank available in 40 or 80 gallon volume. Assembly includes tank, valve, piping, tubing, and pressure gauge.

  • 40 Gallon Tank Assembly - Part # A612-40
  • 80 Gallon Tank Assembly - Part # A612-80

Tank Level Controls

Tank Level Controls for Commercial RO SystemsTurns system on or off according to the water level in an atmospheric storage tank.

  • Dual float assembly provides system on/off controls.
    Part # YFL2PPAS
  • Triple float assembly provides system on/off as well as low level protection on/off for a repressurization pump.
    Part # YFL3PPAS

Atmospheric storage tank and repressurization pump are sold separately.


Atmospheric Storage Tank

Atmospheric Storage Tank for Commercial ROAtmospheric Permeate Storage tank. Assembly includes bulkheads and vent filter. For use with Tank Level Controls (sold separately).

  • 200 Gallon Part # A613-200
  • 400 Gallon Part # A613-500

Delivery System

20 GPM, 50 PSI, 220v/1ph/50-60Hz

Includes Pump, 40 Gallon Pressure Tank, Controls and Fittings

Part # A606-216


Prefilter Pressure Gauge

Prefilter Differential Pressure Gauge for Commercial ROTo allow for monitoring of the in and out pressure of the prefilter in order to indicate when the cartridge needs to be changed. Assembly includes pressure gauge and fittings.

Part # A623


Floor Casters Kit

Casters for Commercial RO System2 Locking casters and 2 Swivel casters to mount at the base of the stand for ease of system mobility.

Part #: A625


Replacement Parts & Consumables for HLS Series Brackish Water Reverse Osmosis Systems