XL系列低能耗
XL系列低能耗RO系统
这些小型商用低能耗 RO 系统旨在从自来水或井水中生产低溶解固体水,使用运行压力为 100-140 psi 的超低能耗 XLE 反渗透膜。
产品水非常适合无斑点冲洗、水库、全屋系统、实验室、制冰机、加湿、喷雾等应用。
作为 L 系列的一部分(与 L 和 HL 系列一起),这些完整的反渗透系统最适合总溶解固体 (TDS) 低于 1,000 PPM 的给水。
该系统采用久经考验的可靠组件,并安装在坚固的粉末涂层金属框架上。多年的经验铸就了该系统的设计,通过智能工艺和流体工程,确保最佳的膜寿命并最大限度地减少污垢。

型号 |
系统容量 |
4x40 膜元件数量 (XLE) |
管线尺寸 |
系统尺寸 |
大约运输重量 |
|||||
国内生产总值 |
立方米/天 |
进口 |
烫发。 |
浓度 |
长度 |
深度 |
高度 |
|||
XL-14A-216 |
2,000 |
7.5 |
1 |
¾ |
½ |
½ |
20/51 |
28/71 |
54/137 |
275/125 |
XL-24A-216 |
4,000 |
15 |
2 |
¾ |
½ |
½ |
20/51 |
28/71 |
54/137 |
300/136 |
XL-34A-216 |
5,800 |
22 |
3 |
¾ |
½ |
½ |
20/51 |
28/71 |
54/137 |
325/147 |
XL-44A-216 |
7,500 |
二十八 |
4 |
¾ |
½ |
½ |
20/51 |
34/87 |
54/137 |
350/159 |
XL-54A-216 |
9,000 |
三十四 |
5 |
¾ |
½ |
½ |
20/51 |
34/87 |
54/137 |
375/170 |
XL-64A-216 |
10,000 |
三十八 |
6 |
¾ |
½ |
½ |
20/51 |
34/87 |
54/137 |
400/181 |
说明和电压/订购信息
- 所有尺寸和重量均为近似值。
- 容量基础: 24 小时/天
- 系统额定温度: 77°F (25°C),使用1,000 ppm氯化钠溶液,工作压力约为200 psi。系统处理能力随水温变化显著。对于更高的TDS(总溶解固体)浓度,必须提供水质分析报告,这可能导致系统改造或从XL系列系统更换为L系列或HL系列系统。
- RO 系统的最低进料压力: 40-60 PSI。
- 如果给水中含有氯,则必须在进入 RO 系统之前使用碳过滤器或注入化学药剂除去氯。
- 应使用软化剂对水硬度进行预处理,以避免膜结垢。
- 进水浊度:小于1 NTU;进水粉尘密度指数 (SDI):最大3。如果超过,建议使用介质过滤器进行预处理。所有预处理设备和SDI测试套件均可从Applied Membranes公司购买。
-
电压代码: 216 = 220 -240v/1ph/60hz • 215 = 220-240v/1ph/50hz。
XL系列不提供三相或其他电压。请参阅L系列或HL系列。
- 使用采用 XLE RO 膜的低能耗 RO 系统可显著降低您的运营成本
- 40 多年的经验体现在我们的质量上
- 紧凑、重型、粉末涂层框架
- 整个 RO 系统使用经过验证的组件
- 保守设计,确保长期可靠的性能
- 经过工厂测试,确保无故障运行
Standard Equipment
|
|
Microprocessor Controller for Automatic Operation
- Spot Free Rinse/Car Wash
- Water Stores
- Whole House
- Laboratories
- Large Office
- Institutions
- Ice Makers
- Humidification
- Misting
- Commercial
- Manufacturing
- Rinse Water And a wide variety of other applications
Optional Add-On Parts and Equipment for Low Energy Commercial RO Systems
AMI's XL Series Energy Saving RO Systems are available with a wide variety of optional add-on equipment. All assemblies include hardware and mounting equipment for easy upgrade to your new or existing system installation.
Wall Mount Filter Cartridges
Includes mounting bracket and Isolation Valves to close the line when changing the filter cartridge.
Part # A711
Filter cartridge must be ordered separately - common options are shown below. Any 20" Big Blue size cartridge can be installed. Click here to view our complete filter cartridge product selection.
Pretreatment Options Available:
- Sediment Filters in a variety of micron ratings -
- Scale Inhibitor Cartridges: H-F4220-NS
- Block Carbon Filter Cartridges Block Carbon filter cartridges produce no carbon fines.
- KX Brand: 32-425-125-20. Click for Product Details
Post-treatment Options Available:
- Calcite Filter Cartridge to neutralize the pH of the RO permeate water - Filter Model H-F4220CALCITE Click for Product Details
- DI Filter Cartridge with Mixed-Bed Deionization Resin for ultrapure applications - Filter Model: H-F4220DI Click for Product Details
Softeners & Media Filtration Pre/Post Treatment
AMI Media filters feature fully automatic backwash or regeneration for easy, trouble free maintenance. Ensure superior system operation and extended membrane life by providing proper pretreatment to the incoming feed water on a continuous basis. Common pretreatment or post-treatment methods include:
- Single or Twin Water Softener to remove hardness and scale.
- Multi-Media Filter for sediment filtration to approximately 10 microns.
- Carbon Filter to remove chlorine.
- Calcite Filter to neutralize the pH of the RO product water.
Click Here to visit the Media Filtration section of our site for detailed information on the full line of media filtration products we carry.
Chemical Injection System
Antiscalant injection as an alternative to a water softener for scale control, or
Sodium Metabisulfite injection as an alternative to a carbon filter to remove chlorine.
Water Quality Monitors
Pre-packaged wall-mountable water quality monitoring controls allow you to monitor the quality of the incoming feed or RO product water. Assembly includes the monitor, enclosure and sensor.
Available Options for Monitoring Incoming Feed Water Quality:
- ORP - 60Hz Part # A246, 50Hz Part # A247
- pH - 60Hz Part # A244, 50Hz Part # A245
Available Options for Monitoring RO Product Water Quality:
- Total Dissolved Solids (TDS) - 60Hz Part # A242, 50Hz Part # A243
- Resistivity - 60Hz Part # A248, 50Hz Part # A249
- pH - 60Hz Part # A244, 50Hz Part # A245
Ultraviolet (UV) Systems
Add an ultraviolet water sterilizer for a 99.9% reduction of bacteria and viruses in the feed and/or permeate line.
Note: For feed line, wall-mount filter cartridge assembly shown above is required.
Tank Pressure Controls
To automatically turn the RO system on or off with the permeate storage tank level. For use with a pressurized storage tank (sold separately).
- 220v/60Hz - Part # A621
Pressurized Storage Tank
Pressurized permeate storage tank available in 40 or 80 gallon volume. Assembly includes tank, valve, piping, tubing, and pressure gauge.
- 40 Gallon Tank Assembly - Part # A612-40
- 80 Gallon Tank Assembly - Part # A612-80
Tank Level Controls
Turns system on or off according to the water level in an atmospheric storage tank.
- Dual float assembly provides system on/off controls.
Part # YFL2PPAS - Triple float assembly provides system on/off as well as low level protection on/off for a repressurization pump.
Part # YFL3PPAS
Atmospheric storage tank and repressurization pump are sold separately.
Atmospheric Storage Tank
Atmospheric Permeate Storage tank. Assembly includes bulkheads and vent filter. For use with Tank Level Controls (sold separately).
- 200 Gallon Part # A613-200
- 400 Gallon Part # A613-500
Delivery System
20 GPM, 50 PSI, 220v/1ph/50-60Hz
Includes Pump, 40 Gallon Pressure Tank, Controls and Fittings
Part # A606-216
Prefilter Pressure Gauge
To allow for monitoring of the in and out pressure of the prefilter in order to indicate when the cartridge needs to be changed. Assembly includes pressure gauge and fittings.
Part # A623
Floor Casters Kit
2 Locking casters and 2 Swivel casters to mount at the base of the stand for ease of system mobility.
Part #: A625
Replacement Parts & Consumables for HL Series Reverse Osmosis Systems
- Replacement Reverse Osmosis Membranes for Commercial RO Systems
- Replacement Membrane Pressure Vessels for Commercial RO Systems
- Replacement Sediment Filters for Commercial RO Systems
- Replacement Carbon Filters for Commercial RO Systems
- Replacement Filter Housings for Commercial RO Systems
- Replacement Components for Commercial RO Systems
- Membrane Cleaning Cartridges for Commercial RO Systems
排序方式